Zhejiang Canaan Kaixinlong Technology Co., Ltd.
Canaan Kaixinlong, Focus on automatic capsule filling machine
Add to Cart
Overview of the machine:
Powerful Capsule Filling Machine For Pharmaceutical Factory Capsule Factory Hard Capsule Filling Machine Filling Machine
Technical parameters:
| Output | 7500Capsules/min |
| No.of segment bores | 54(four rows) |
| Suitable fof capsule | 00#-5# |
| Total power | 18Kw(Standard configuration) |
| Overall weight | 4000Kgs |
| Overall diemensions | 1884+(530)mmX1404+(275)mmX2148mm |
| Noise | ≤80DB(A) |
| Pressure | 0.4 ~ 0.7Mpa |
| Air consumption | ≤18m³ |
| Vacuum | -0.03 ~ -0.06Mpa |
| Filling error | ±3%~±7% |
The machine may make technical improvements without prior notice, and the attached picture shows the options that may be offered.
The process of capsule filling:
Expansion diagram of the working principle:
| principle The seeding tube is equipped with multiple circular holes and communicate with the capsule hopper, and the channel is equipped with capsule tablets. The seeding sac tube slides up and down to drop the empty capsule into the pore channel. When the seeding capsule tube goes up, the capsule piece will jam the capsule. When the seeding tube falls down, the capsule holder rotates and drives the capsule to release the capsule, and the capsule falls out of the hole. | |
Orientation of the empty capsule:
Body cap separation of the empty capsule:
Rejection station:
| Use Some empty capsules may keep the body cap still for some reason, and remain in the upper module hole; to prevent mixing into the finished product, they are removed before the capsule is closed. Principle A push hand that can reciprocate up and down, located between the upper module and the lower module, with a thimble hand. When the upper and lower modules rotate, the push hand stops at the lower limit position and the thimble breaks away from the upper module. When the module stops at this station, the push hand goes up and the thimble mounted on the push hand is inserted into the upper module hole. ①. If there is a pulled out capsule cap in the upper mold hole, the upward top has no impact on the capsule cap. ②. If there is an open empty capsule in the upper mold hole, the upper module is pushed out by the upward thimble and sucked into the air chamber. | |
Locking station:
| Use Lock the capsule of the push rod to meet the requirements of the finished product. Principle The upper and lower modules are rotated to the lock, when the axis of the upper and lower modules overlap. The upper baffle above the module begins to move against the top bar below. The upper baffle presses the capsule cap, the top rod rises, and the capsule cap body is closed and locked | |
Finished capsule discharge station:
| Use The finished capsules will be pushed out for collection. Principle The main component of the device is a discharge top rod that can reciprocate up and down. When the upper and lower modules carrying the closed capsule are rotated above the exit station and stopped, the capsule is pushed out of the module hole. The capsule was then blown into the outgoing hopper and slid into the stock barrel. | |
Cleaning station:
| Use The cleaning unit cleans the module for access to the next cycle. Principle When the upper and lower modules are dragged under the main working plate and parked at the cleaning station, they are placed at the gap of the cleaning device. At this time, the compressed air is opened, and the powder in the mold hole and the broken skin are blown out of the mold hole from the lower direction of the lower module. The vacuum suction system placed above the mold hole draws it into the vacuum cleaner to keep the mold hole clean and to facilitate the next cycle operation. | |